Unlock Bootloader Google Pixel 3 Pixel 3 XL

Unlock Bootloader Google Pixel 3 Pixel 3 XL

Google Pixel 3 Pixel 3 XL was Released in October 2018. It comes with Pie Version. Pixel Mobiles Are Clean Android, If you feel You Want to Use Custom ROM, You Have to Install Custom ROM Using TWRP. You can do this By rooting. Bootloader Unlocking is Necessary to Perform Rooting and Flashing Firmware. Bootloader Unlock Voids Your Warranty.

Note
  • Battery level above 80 Percent.
  • Should Backup Your Device(Full Data loss Process).
  • Google Pixel 3 Pixel 3 XL Devices Only.
  • It Will Not Work For Verizon, There is a Separate Article For Verizon Devices.
  • Bootloader Should Be Unlocked For Performing Flashing and rooting.
  • Download(Windows)/Download(Mac) Respective ADB Drivers and Install it your system.
  • Unlock Your Pixel Before Doing this.if you already Unlocked it You can move to Flashing Directly.
  • Enable USB Debugging Mode->Tap 7-10 Times in Build Number->Enable USB Debugging Mode.
  • In your Mobile Go to Setting>Developer options>Enable Oem Unlock.
  • Switch off your Mobile.
  • Put your Mobile in Boot Loader Mode-Follow Below Steps.
  • Press and hold the Volume Down button for about 2-3 seconds.
  • Holding Volume key press the Power key for a short while.
  • Release All Keys.
  • Connect Your Mobile via USB Cable.
  • In the Command Prompt cd/adb folder name.
  • Type the Following Command.
  • adb reboot bootloader-(Windows)
  • ./adb reboot bootloader-(Mac).
  • If the Above Command is Not Working Means Check with the Below code.
  • The Command Should return Some Serial Numbers.
  • fastboot –(Windows)
  • ./fastboot-(Mac)
  • If your Device is Detected you will get the Device ID.
  • Repeat the above steps from Bootloader mode, If you didn’t get the ID.
  • If your Device has detected the type the following
  • fastboot oem unlock-(Windows)
  • ./fastboot oem unlock-(Mac).
  • You will need to confirm the operation in your handset by Volume up Button.
  • You will Get the Success message as Unlocked Successfully.
  • If you Didn’t Get Success Message, try With Below Command.
  • fastboot flashing unlock_critical-(Windows)
  • ./fastboot flashing unlock_critical-(Mac).
  • You will Get the Success message as Unlocked Successfully.
  • When you Get this message press the Volume Keys and navigate the Start then Press Power Button.
  • The Mobile will Restart. It Will take some time to Boot in the First Boot.

Share This: